Short answer: To fix a leaking dam, first prove the loss is seepage rather than evaporation, then find the leak path and match the repair to the soil. WA government figures put success at about 80% for a compacted clay blanket, about 50% for a bentonite blanket and over 90% for an HDPE or polypropylene liner.

A leaking dam is the most common call we take, and most owners assume the wall has failed. In practice the leak is often in the floor, a poorly compacted contact zone, a pipe through the wall or an old root run, and the repair has to suit the soil you actually have. Choose the wrong fix and you can make the leak worse.

Lindsey Hughson has built and repaired farm dams since 2004, more than 341 dams across NSW, Queensland and Victoria in 22 years. The order below is the one we follow on every leaking dam before we quote any work.

Buying bentonite? Bentonite Pro is Big Ditch’s own bentonite supply company, 100% backed by Big Ditch’s 22 years of dam building experience. It supplies sodium bentonite in bulk bags, delivered across NSW, VIC and QLD.

Step 1: Prove the dam is leaking, not evaporating

Evaporation from an open farm dam in an Australian summer can take more depth than most owners expect, so measure before you spend. The farm dam evaporation guide explains the rates; the test below separates the two losses.

Seepage is water moving slowly through the floor, wall or foundation of a dam. A leak is a concentrated path, such as a tunnel, crack or pipe run, that carries water out faster.

  1. Stand a bucket of water in the shallows, weighted so it cannot float or tip.
  2. Fill the bucket to the same level as the dam and mark both water lines.
  3. Wait seven dry days with no pumping or stock drinking from that dam if you can.
  4. Measure the drop inside the bucket and the drop in the dam.
  5. Subtract the bucket drop from the dam drop and divide by seven for seepage in millimetres per day.

Cotton industry guidance gives useful benchmarks for that number, according to the CottonInfo storage seepage fact sheet.

Seepage rate (mm per day)What it means
1 or lessNormal for a well-built dam on heavy clay
2 to 5Typical of silty or sandy soil
More than 5Intervention is recommended

How can I tell if my dam is leaking or just evaporating?

Run the bucket test for at least seven consecutive dry days. If the bucket and the dam drop by the same amount, you are watching evaporation. If the dam drops faster, the difference is seepage. A gap above 5 mm per day usually justifies repair work, and a gap that grows when the dam is fuller points to a leak path high in the wall.

What does a leaking dam wall look like?

Walk the downstream batter early in the morning. Look for damp ground, rushes or brighter green grass at the toe, a darker seepage line on the face, or a trickle at or below natural ground. The NSW Government farm dam guide notes that a green patch below the dam that persists into summer is a good signal of a leak. Muddy water, sinkholes on the crest or boils at the toe mean internal erosion and need assessment before the dam is refilled.

Step 2: Find where the water is going

The repair depends on the leak path, so locate it before choosing a method. Our guide to why dams leak covers each cause in detail.

  • Follow wet ground uphill to the highest point it reaches; the leak path is usually close by.
  • Note the level where losses slow or stop; the leak usually sits at that height.
  • Check around any pipe through the wall, because water tracks along the outside of poorly bedded pipes.
  • Walk the upstream face at low water for yabby, rabbit and wombat holes.
  • Auger or trench the floor to see what soil sits below the waterline.

Leaking dam repair methods compared

The Western Australian Department of Primary Industries and Regional Development (DPIRD) publishes the clearest comparison of repair methods, with success rates and costs relative to a replacement dam, in its guide to treating leaky farm dams.

Repair methodDam must be empty?Success rateCost compared with a new dam
Blend and compact the existing soilYesAbout 50%One third to two thirds
Local clay blanket, 1 m compactedYesAbout 80%1.5 to 3 times
Bentonite blanket, mixed or pureYesAbout 50%About 2 to 3 times
Gypsum soil treatment for dispersive clayYesAbout 80%Not stated
HDPE or polypropylene linerYesMore than 90%Highest of the options

DPIRD also notes that if another suitable dam site is available, building a new dam may be the cheapest and most effective option.

When does blending and compacting the existing soil work?

Blending and compacting suits a dam whose floor has enough clay but was never compacted properly. The dam is drained, the soil is ripped, brought to the right moisture and rolled in layers no thicker than 200 mm, the maximum DPIRD gives for good compaction. It is the cheapest repair, but a success rate of about 50% makes it best for marginal dams rather than badly leaking ones.

When is a compacted clay blanket the right repair?

A clay blanket is the most reliable earthworks repair when suitable clay is close to the dam. DPIRD recommends a 1 m thick compacted blanket to cut seepage to a maximum of 2 mm per day, costed on compaction to at least 92% of maximum dry density.

The NSW DPI leaking farm dams guide sets a minimum of 300 mm of compacted clay in all cases, placed in layers at optimum moisture. Good dam clay is well graded, contains at least 20% clay and shows little or no dispersion when tested.

How much bentonite does a leaking dam need?

Bentonite is a natural clay that swells when wet and lowers the permeability of the soil layer it is placed in. It works on floors and batters where the soil is porous; it does not fix a tunnel, a pipe leak or a wall with poor compaction.

Government guides give a range of rates. NSW DPI describes about 7 kg/m² mixed into the top 150 to 200 mm for a mixed blanket and about 10 kg/m² for a pure blanket, while DPIRD suggests 15 kg/m² of high grade sodium bentonite. Big Ditch and Bentonite Pro recommend 30 kg/m² of sodium bentonite on a drained, prepared floor, which builds in a margin for uneven spreading. Our bentonite dam sealing guide covers the method in full.

Cover a pure blanket with at least 100 mm of site soil so it does not crack as it dries, and at least 450 mm where stock can reach it, according to NSW DPI.

Do gypsum and STPP sealants work?

Gypsum and sodium tripolyphosphate (STPP) change how clay disperses; they are not waterproofing products. Gypsum blended into the top 200 mm of a drained embankment at 4 kg/m², or 1% by weight, treats minor piping in dispersive clay with about 80% success.

DPIRD does not recommend adding gypsum to the water to treat an existing leak. Its water treatment rate of 1 kg per 10 m³ is for preventing leaks in dispersive clay dams, with about 50% success and repeat doses every 2 or 3 years.

STPP needs expert design and supervision. In 20% of treated dams, supervised application at recommended rates has greatly increased seepage through induced piping failure, according to DPIRD.

When does a synthetic liner make sense?

An HDPE or polypropylene membrane liner has the highest success rate, above 90% in DPIRD’s figures, and suits critical supplies such as household or dairy water. DPIRD notes 1 mm polypropylene costs about 25% more to supply and install than 1.5 mm HDPE, offset by cheaper foundation preparation. Liners also bring their own risks, which we cover in why liners can be a poor choice for farm dams.

Can you fix a leaking dam without draining it?

Sometimes, if the leak is small, the wall is stable and the problem is seepage rather than a tunnel or failed pipe. Most permanent repairs still need the water down so the leak surface can be exposed, tested and compacted.

Repairs that can work with water in the dam include:

  • Fencing stock off the wall so hooves stop opening cracks and holes.
  • Packing animal holes from the outside with moist clay, placed and tamped in thin layers.
  • Cutting a trench from the crest through a wet section of wall and rebuilding it with good clay in thin, compacted layers.
  • Placing a compacted clay blanket on the upstream face where the leak is diffuse and an excavator can reach.

Broadcasting bentonite onto the water is the option most often suggested, and NSW DPI describes it as at best hit and miss. Superabsorbent polymer sealers are also sold for full dams; we do not recommend them, for the reasons set out in our review of polymer dam sealers.

When must the dam be drained?

  • Muddy or cloudy water leaving the downstream toe, a sign of internal erosion.
  • A sinkhole or soft, collapsing spot on the crest.
  • A fast leak that drops the level every day in mild weather.
  • Large trees growing on the wall or crest.
  • Water tracking along the line of an outlet pipe.

In these cases, lower the water, remove the failed material and rebuild the section properly. Where a large dam could put people or property at risk, Dams Safety NSW publishes a small dam safety guide for owners.

Fix the cause, not just the leak

Most leaking dams have two problems: the leak itself and the damage that keeps reopening it. A seal on a wall that wombats are still digging into will fail again.

ProblemUsual repair
Porous or sandy floorClay blanket, bentonite blanket or liner
Poorly compacted section of wallExcavate and rebuild in thin, compacted layers
Animal burrow through the wallControl the animals, excavate the burrow, backfill with clay and compact
Leak along an inlet or outlet pipeExcavate the pipe, reseal or remove it and recompact
Tree roots in the wallRemove the tree and root runs, then replace the affected clay
Spillway scour or overtoppingReshape, armour and resize the spillway

Our guide to trees on dam walls explains why cutting a tree off at ground level does not stop a root leak.

Refill slowly after a repair

Fill a repaired dam at no more than 30 cm a day where you can, DPIRD advises, so the lining wets evenly and the load on the embankment builds gradually. Rapid filling of a dry embankment can open crack lines that grow into tunnels.

What a Big Ditch leaking dam inspection covers

Every leaking dam quote starts with a site inspection, which costs $500 including GST. If you would rather have the leak found and fixed for you, see our dam sealing and leaking dam repair service. To talk it through first, contact Big Ditch and tell us what the dam is doing.

  1. Measure the seepage rate with the bucket test or your own level records.
  2. Trench or auger the floor to confirm the soil below the waterline.
  3. Test soil for clay content and dispersion where the visual check is inconclusive.
  4. Walk the wall for seepage, tunnels, burrows, roots and pipe leaks.
  5. Match the repair method to the soil, the leak rate and your budget.
  6. Provide a fixed-price quote covering drainage, treatment, compaction and refill.

Frequently asked questions

How much does it cost to fix a leaking dam in Australia?

It depends on the method and the cause. DPIRD puts blending and compacting at one third to two thirds of the cost of a new dam, a 1 m clay blanket at 1.5 to 3 times, a bentonite blanket at about 2 to 3 times and a liner highest of all. Small repairs such as a single burrow cost far less. We price each job after the site inspection.

Will bentonite seal any leaking dam?

No. Bentonite works on porous floors and batters that can be drained, prepared and covered. It does not repair poor compaction, piping along a pipe or root channels, and saline or hard water reduces how well it swells. Check the cause of the leak before ordering bentonite by the tonne.

Is it cheaper to repair a leaking dam or build a new one?

Often a repair is cheaper, but not always. DPIRD costs a clay or bentonite blanket at up to 3 times a new dam, and suggests building elsewhere if a better site exists. Where the original site has unsuitable soil throughout, a new dam in good clay is usually the better investment.

Updated October 2026 to reflect the merger of four Big Ditch leak repair guides into this one, and current WA and NSW government guidance on repair methods and success rates.

Watching your leaking dam drop faster than the weather explains? Book a site inspection with Big Ditch and we will find the leak before you spend money on the wrong fix.

Practical dam advice, straight to your inbox

Get an email when Big Ditch publishes a new article about dam construction, repairs or water management.

Get dam updates

Confirm your email to subscribe. Unsubscribe at any time. Privacy Policy